Description
The Baja Kits Chevy Silverado Long Travel Race kit is built to conquer Baja in your 2WD Chevy Silverado. All factory suspension components are replaced with our CAD engineered, box construction upper and lower control arms and fabricated upright. We designed this kit with optimum geometry and by having the shock mount, limit strap tab and bump stop mount self- locate on the factory pivot points. Countless hours were spent working with King Shocks development engineers to perfect the tuned, 3.0 inch coilover and 3.0 inch bypass shock package on each corner.
The Baja Kits Advantage:
- CAD designed boxed UCA
- Our custom Hi-Density Custom Bushings with grease fittings offer industry leading durabilty and a quiet, no squeak ride
- 1" Hi angle Trophy Truck grade uniball's replace the weak stock ball joints that fail under high angles and loads seen from normal offroad use
- We've increased the caster angle that you lose when lifting a truck with stock arms to regain on road stability, handling and alignment
- Full Heim steering
- King 2.5 Bump stop
Technical Specs:
Track Width 5" wider per side (90" wide overall - Depending on tire width and wheel size)
Wheel Travel 17" Standard (up to 19" with custom fab and engine bay parts relocation)
Lift - 4"
Product Requirements:
Shocks - Custom King Shocks
Tire Size - 37" will require significant trimming even with fiberglass fenders
Wheel Size - 17" rim with 5" max backspacing
Fenders - Fiberglass fenders are required
**Must fabricate engine hoop to connect shock mounts to each other and down to frame (See Instructions for examples)
Parts Included:
**Kits come pre assembled and ready for install, as seen in product photos**
Boxed Upper Arms
Baja Kits Badges & Rivets
Adjustable Rod Ends
Misaligns
Hardware
Boxed Lower Arms
Baja Kits Badges & Rivets
1" Uniballs at the inner pivots
Stainless uniball Spacers
1.5" Uniball at the outer pivots
Stainless 1.5" Misaligns
Shock Bolts and Nuts
Fabricated 4130 Uprights
1" Upper uniball
1" Misaligns
Steering
Billet Clevis
Custom CNC Clevis bolt
Tie rod
Rod ends
Misaligns
Hardware
Additional Items
Weld on bumpstop mount
Brakelines, Fittings,Adapters and Copper Washers
Limit Straps with Hardware & Weld on Frame Tab
Shock box Weldment with shock hardware (Self Locating, Custom, sheetmetal shock mount)
Install Guide
Baja Kits Sticker pack
Install Information:
Level 3 Install: Welding, Drilling, Grinding, and Fabrication required.
Install Time: 40 hours (Times will vary depending on knowledge and skill level)
Install MUST be performed by an experienced fabricator with suspension knowledge and setup.
Mandatory Items to be fabricated:
Shock mount support structure,Strut Bar, or engine cage. A tube structure to connect Driver and Passenger Shock mounts together across/over the engine
Shock Box Support Tubes. These tubes are needed to support the shock mounts to the frame (Fore/Aft)
Write the First Review!